Preparation; Initial Installation - Harbor Breeze 41239 Manual Del Usuario

SAFETY INFORMATION
CAUTION: Read all instructions and safety information before installing your new fan . Review the
accompanying assembly diagrams .
CAUTION: Be sure the outlet box is properly grounded or that a ground (green or bare) wire is present .
CAUTION: Carefully check all screws, bolts and nuts on the fan motor assembly to ensure they are
secured .
CAUTION: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules . These limits are designed to provide reasonable
protection against harmful interference in a residential installation . This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications . However, there is no
guarantee that interference will not occur in a particular installation . If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
--Reorient or relocate the receiving antenna .
--Increase the separation between the equipment and receiver
--Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help .
Please note changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment .

PREPARATION

Before beginning the assembly of this product, ensure that all parts are present . Compare all parts
with the package contents list and hardware contents list . If any part is missing or damaged, do not
attempt to assemble the product .
Estimated Assembly Time: 120 minutes
Tools Required for Assembly (not included): Electrical Tape, Phillips Screwdriver, Pliers, Safety
Glasses, Step Ladder, Wire Cutters and Wire Strippers
Helpful Tools (not included): AC Tester Light, Tape Measure and Wiring Handbook

INITIAL INSTALLATION

1 . Turn off the circuit breakers and the wall switch to the
fan supply line leads .
DANGER: Failure to disconnect the power
supply prior to installation may result in serious injury
or death .
1
6