Rs232 Interface Cable To I-Dt61Xwe; Mounting Bracket - OHAUS Defender 6000 Manual De Instrucciones

Defender 6000 Indicators

2.3.4 RS232 Interface Cable to i-DT61XWE

Pass the optional RS232 cable through the strain relief and attach it to the RS232 connector on the mainboard.
Tighten the strain relief to maintain a watertight seal. Please refer to Figure 2-7 for the postion of the
serial port connector RXD TXD and GND.
Note:
 Please refer to Opeing the Housing section for how to open the case of the terminal.
 For details about Discrete Input0 function, please refer to the Discrete I/O (for i-DT61XWE) section for
details.
RS232
connector
Figure 2-6 RS232 connector on the
2.4

Mounting Bracket

Attach the bracket to a wall or table using fasteners (not supplied) that are appropriate for the type of mounting
surface. The bracket will accommodate up to 6 mm (1/4") diameter screws. Locate the mounting holes as
shown in Figure 2-8 and 2-9.
Figure 2-5
Strain Relief for Option
mainboard
Discrete Input0
Figure 2-7
RS232 connector
Figure 2-8 i-DT61PW
Mounting Bracket Dimensions
Figure 2-9 i-DT61XWE
Mounting Bracket Dimensions
EN-15