OHAUS Defender 6000 Manual De Instrucciones página 33

Defender 6000 Indicators
A.
[ tArE]
Auto Tare
Set the automatic tare functionality.
Off
= automatic tare is disabled.
ON
= the first stable gross weight is tared.
ACCept
= stable gross weights within the acceptable limits are tared (in Check mode).
[
ACCUmM
Accumulation
Set the accumulation functionality.
OFF
= accumulation is disabled.
aUtO
= perform accumulation automatically.
mMAN
= perform accumulation manually.
ACCEPt
= perform accumulation when weights are within the acceptable limits (in Check mode).
Note: For details about accumulation, pleaser refer to Accumulation and Statistics in Weighing Mode
section.
Transaction Counter
The transaction counter is a seven-digit counter that tracks the total transactions. When the value reaches
9,999,999, the next transaction causes a roll-over to 0000001.
Off
= the transaction counter will not increase.
ON
= the transaction counter will increase with the additional menu item Next Transaction available.
Note: If the transaction counter is set to be ON, the count number will increase when press the Print
button.
Next Transaction Counter
Set the value of the next transaction displays in the Next Transaction field.
1~999999
[
K.Beep
Key Beeper
Set whether the beeper is enabled when a button is pressed.
Off
= no sound
ON
= sound
Note: This setting is only avaliable for i-DT61XWE model.
Key Click Type
SINGLE
= single click the button to execute operation.
dOUbLE
= double click the button to execute operation.
Note: This setting is only avaliable for i-DT61XWE model.
[bp.SIG]
Beeper Signal
Set the condition for beeper sound in Check Weighing mode.
OFF
= the beeper is disabled.
UNder
= the beeper sound is enabled when the weight is below the under value you set.
Ouer
= the beeper sound is enabled when the weight is above the over value you set.
aCCept
= the beeper sound is enabled when the weight is within the acceptable range you set.
UN-Ou
= the beeper sound is enabled when the weight is below the under value or above the over value
you set.
Note: This setting is only avaliable for i-DT61XWE model.
Check Light signal
Set how the display shows in Check mode for over, under and acceptable weight.
blOCk
= the light is shown in block.
bar
= the light is shown in bar.
sEGmENt
= the light is shown in segment.
Note: This setting is only avaliable for i-DT61XWE model.
]
[ ]
t.CNt
[ ]
t.NEXt
]
[ ]
K.CLICK
[ ]
L.SIGN
EN-31