Kichler Cameron Manual De Instrucciones página 8

HANGING THE FAN
Step 6. Loosen the two set screws and remove the hitch pin and retaining clip
from the coupling on top of the motor assembly. (Fig. 8)
Step 7. Carefully feed the electrical lead wires from the fan up through the
downrod. Thread the downrod into the coupling until the Hitch pin holes
are aligned.
Next, replace the hitch pin and retaining clip. Tighten both set screws. (Fig. 8)
Step 8. Slip the coupling cover, canopy cover and canopy onto the downrod.
Thread the hanger ball onto the downrod, insert the cross pin through the
downrod and tighten. Now tighten the set screw. (Fig. 9)
8 | KICHLER.COM
Supply wires
Downrod
Coupling
Set screw
Set screw
Hitch pin Retaining clip
PL-190B
Fig. 8
Cross pin
Hanger ball
Hanger ball
Downrod
Coupling cover
Canopy cover
Coupling
Fig. 9
Canopy