Finishing The Installation - Kichler Cameron Manual De Instrucciones

MAKE THE ELECTRIC CONNECTIONS
Connect the white wire from the fan to the white wire marked "TO MOTOR N" from the receiver.
Connect the blue wire from the fan to the blue wire marked "FOR LIGHT" from the receiver.
Secure all the wire connections with the plastic wire nuts provided.
Step 3. (Fig. 14) Receiver to House Supply Wires Electrical Connections: Connect the black
(hot) wire from the ceiling to the black wire marked "AC in L" from the receiver. Connect the
white(neutral) wire from the ceiling to the white wire marked "AC in N" from the Receiver. Secure
the wire connections with the plastic wire nuts provided.
Step 4. (Fig. 14) If your outlet box has a ground wire (green or bare copper) connect it to the fan
ground wires; otherwise connect the hanging bracket ground wire to the mounting bracket. Secure
the wire connection with a plastic nut provided. After connecting the wires, spread them apart so
that the green and white wires are on one side of the outlet box and black and blue wires are on the
other side. Carefully tuck the wire connections up into the outlet box.
NOTE: Fan must be installed at a maximum distance of 30 feet from the CoolTouch
Transmitter for optimal signal transmission between the transmitter and the fan's receiving unit.

FINISHING THE INSTALLATION

Step 1. Tuck all the connections neatly into the ceiling outlet box.
Step 2. Slide the canopy up to the mounting bracket and place one of the key hole slots over the
mounting screw on the mounting bracket. Rotate the canopy until the screw head locks in place at
the narrow section of the key hole. See figure 15.
Step 3. Align the remaining circular hole on the canopy with the remaining hole on the Ceiling
Mounting Bracket. Insert and tighten the mounting screw you removed earlier and the mounting
screw from Step 2 above. Now, attach the canopy cover to the mounting screw heads by inserting
the screw heads into the bottom side of the canopy cover and rotating the cover clockwise.
NOTE: Adjust the canopy screws as necessary until the canopy and canopy cover are snug. (Fig. 15)
12 | KICHLER.COM
Outlet box
Black (hot)
Black ("AC IN L")
Receiver
Black ("to motor L")
Blue (for light)
Blue (for light)
Black (motor)
Remote
™
Outlet box
Ceiling
mounting
bracket
Screws
White (neutral)
Green or bare
copper (ground)
White ("AC IN N")
White ("to motor N")
(Connect to
Ground
ground wire on
(green)
hanger bracket if
no house ground
wire exists.)
White (neutral)
Fig. 14
Screws
Canopy
Canopy cover
Fig. 15