Attaching The Fan Blades; Installing The Light Plate - Kichler Cameron Manual De Instrucciones

ATTACHING THE FAN BLADES

Step 1. Attach a blade to a blade bracket using the screws and rubber washers provided.
(Fig.16)
Make sure the blade is straight when set on the blade bracket. Tighten each mounting
screw and then repeat this procedure for each blade.
Step 2. Attach each blade assembly to the motor using the "Pre-Installed" mounting
screws in the blade bracket. (Fig 16)

INSTALLING THE LIGHT PLATE

Step 1. Loosen the two screws on the mounting ring attached to the motor shaft
and "remove" and save the third screw. (Fig. 17)
Step 2. Place the key hole slots on the light plate over the two screws previously
loosened on the mounting ring.
Turn the light plate until is locks in place at the narrow section of the key hole slots.
Tighten both key hole screws and replace the third screw previously removed and
tighten securely.
Screws
Blade brackets
Fig. 16
Mounting ring
Light plate
Screws
Fig. 17
Cameron
Screws
Rubber
washers
Blades
13
|
™