Make The Electrical Connections - Kichler Cameron Manual De Instrucciones

MAKE THE ELECTRIC CONNECTIONS
WARNING: To avoid possible electrical shock, be sure you have turned off the
power at the main circuit panel.
NOTE: In the Transmitter, Set Dip Switch #5 on the D position. This enables the
dimming function.
NOTE: The CoolTouch
™ Control System is equipped with 16 possible frequency
combinations to prevent interference from or with other remote control units.
The frequency switches on your receiver and transmitter have been preset at the
factory. Please recheck to make sure the switches on transmitter and receiver
are set to the same position, any combination of settings will operate the fan as
long as the transmitter and receiver are set to the same position. (Fig. 12)
Step 1. Insert the receiver into the ceiling mounting bracket with the flat side of
the receiver facing the ceiling. (Fig. 13) For best performance, make sure the Black
Antenna, on the end of the receiver, remains extended and not tangled with any
of the electrical wires.
Step 2. Motor to Receiver Electrical Connections: (Fig. 14) Connect the black wire
from the fan to the black wire marked "TO MOTOR L" on the receiver.
ON
ON D
Dip switch
X
1 2 3 4
Fig. 12
Receiver
Fig. 13
Cameron
Hanger
bracket
11
|
™