Device Settings; Wireless Foot Control; Device Information - B.Braun Aesculap GA800 Manual De Instrucciones

►
Leave menu: Press button "Leave menu" f.
►
Change motor settings: Press button "Reduce value" h or "Increase
value" g.
The change is implemented immediately. The set value is displayed.
►
Reset motor settings to default settings
– Press button "Factory reset" a.
– Confirm message.
Drill tool GA844
The settings below are additionally available for the drill tool GA844:
Setting Description
Oscillation mode Determines whether the oscillation function
on the drill can be activated.
Oscillation angle Total oscillation angle
Thread cutting operation Thread cutting operation angle counter-
angle left clockwise
Thread cutting operation Thread cutting operation angle clockwise
angle right
6.4.3

Device settings

a
b
c
d
e
Fig. 12 Device settings
Legend
a Exit menu
b Set system volume
c Setting display brightness
d Reset system volume and brightness to default settings
e Set system language
f Reduce value
g Increase value
►
Exit menu: Press Exit menu a button.
►
Change system volume/brightness: Press button "Increase value" g or
"Reduce value" f.
The change is implemented immediately. The set value is displayed.
►
Set system language:
– Press button "language" e.
– Select desired language.
►
Reset system volume and brightness to default settings
– Press button "factory reset" a.
– Confirm message.
f g
6.4.4

Wireless foot control

The wireless foot control GA810 can be connected to the control unit or
disconnected from the control unit via the menu "radio footcontrol".
a
Fig. 13 Wireless foot control settings
Legend
a Connect wireless foot control (or disconnect if a wireless foot control
is connected)
►
Connect the GA810 wireless foot control:
– Select Connect to GA810 button and
– follow the instructions on the display. Compare the serial number
in the control unit display to the
– serial number of the wireless foot control and select "Yes" to con-
firm the message.
►
Disconnect the GA810 wireless foot control
– by pressing the "Disconnecting from GA810" button
– or –
– switch off the control unit for approx. 10 min.
6.4.5

Device information

The "device information" menu displays general information about the
device and the device software.
►
Leave the menu: Activate the "Leave menu" e button.
en
15