System Description - Cebora ARCO Manual De Instrucciones

11�1 System description
The CEBORA WINTIG Welding System is a modular system suitable for the following welding processes:
♦
TIG without filler
♦
TIG with cold wire combined with wire feeder Item 1649
♦
Plasma welding combined with gas console for Item 465.01.
In the full configuration, the system is made up of a power source, internal/external cooling unit (optional), a wire feeder
(optional), a plasma welding console (optional), a remote control panel (optional) and a robot interface (optional) - see
Fig. 3-.
In robotised applications, the welding power source is always a Slave node of the communication line, while the robot
interface Item 448/428.XX or the external robot control is the line Master node.
Before starting power source configuration, ensure that the resistance of the CANopen communication line between
the Master node and the Slave node (pin A and B of CN2) is 60 Ohm:
Position Description
1 WIN TIG Robot series power source
2 Robot interface
3 Power source-Robot interface connection
4 Plasma Welding Console
5 Power Source- Plasma Welding Console Connection
6 Cold Wire Feeder
7 Plasma Console Plasma – Wire Feeder Connection
8 Spool holder/snap-on
9 Wire guide sheath
10 TIG/PW remote panel
11 Power source TIG/PW remote panel connection cable
Interfacing with the robot control can take place in three ways:
♦
Via an analog interface Item 448
♦
Via a digital interface Item 428.XX
♦
Direct connection via integrated communication bus CANopen profile DS401: in this case, interface (2) is not
necessary and only optional connection item 2054 is used in its place.
Fig. 2
Item
394/395/396/
380/381.80
428.XX, 448
2063
465.01
2067
1649
2062
121/173
1935
438
2065
Optional
-
X
-
X
X
X
X
X
X
X
X
95/107