FINAL INSTALLATION
Remove three switch housing screws (Q) from
3.
fitter plate (on underside of motor). Connect 9-wire
plug from motor housing (E) to 9-wire plug from
switch housing (F), matching up the colors on the
9-wire plugs for correct fit. (Fig. 3) Make sure plugs
connect tightly.
Carefully arrange wires inside switch housing (F).
Align holes in switch housing (F) with holes in fitter
plate. Re-insert switch housing screws (Q) that
were previously removed. Tighten all three switch
housing screws (Q) securely. (Fig. 3)
4. Locate switch housing screws (Q) on underside of
switch housing (F) rim. Remove switch housing screw
(Q) with a red dot--save for later use. Partially loosen
the other two switch housing screws (Q). (Fig. 4)
Align slotted holes in light kit fitter (I) with loosened
screws in switch housing (F). Twist light kit fitter (I) to
lock. Re-insert switch housing screw (Q) that was just
removed, and then tighten all three switch housing
screws (Q) securely. (Fig. 4)
5.
Connect small male plug from switch housing (F) to
small female plug from light kit fitter (I), (Fig. 5)
Make sure plugs connect tightly.
Install three candelabra-base 40-watt max. bulbs (J)
included. (Fig. 5)
CAUTION: When replacing bulbs, please allow
bulbs and glass shade to cool down before touching.
3
Q
Fitter
Plate
9-wire
Plug
F
4
5
I
Small
Female
Plug
J
14
9-wire
Plug
E
Switch
Housing
Rim
Q
F
F
Small
Male
Plug
E
I
Q