Dyson AM 10 Manual Del Operacion página 71

• In humidifier mode do not use without water in the tank.
• Do not lubricate any part of this appliance.
• When switched on, a small blue LED on the back of the
appliance lights up to show that power is being received by
the appliance. (Note: It does not mean that the appliance
itself is operating.)
• Once the water treatment cycle completes the appliance is
ready to begin humidification.
Setting humidity level
• On first use, the display will show '70%', which is the highest
relative humidity setting. The fan will run on lowest airspeed,
'01'. For each use after this the appliance will remember the
last target humidity level and airflow speed set.
• The appliance will not operate unless the target humidity
setting is above the current room humidity level.
• The appliance will automatically adjust to avoid
excessive humidity.
• Mist will be visible only in certain conditions (impacted by
light, background colour, etc.) or at the lowest settings.
Automatic Mode
• Press the AUTO button on the remote. This is the
recommended mode of operation.
• The appliance selects a comfortable humidity for the room,
based on environmental factors such as current humidity
level and air temperature.
• When the room reaches the appropriate humidity level the
appliance will switch itself 'ON' or 'OFF' as necessary to
maintain that level. The fan will remain running when the
target humidity has been reached.
Manual mode
• Select the desired humidity level (from 30% to 70%). When
the room reaches the target humidity level the appliance
will switch itself 'ON' or 'OFF' as necessary to maintain that
level. The fan will remain running when the target humidity
has been reached.
Fan mode
• The fan mode button on the remote control turns the
humidifier mode 'OFF'. Control the fan mode using the
airflow and timer buttons.
• No water is needed for the fan mode.
Control without the remote
• Press the power button on the appliance to turn ON/OFF.
• Press and hold the power button on the appliance to adjust
the humidity setting.
71
away from traffic areas so that it will not be tripped over
or damaged.
• Clean the appliance and tank as instructed before storing
and before re-use.
Battery replacement
CAUTION
• Unscrew the battery compartment on the remote control.
Loosen the base and pull to remove the battery.
• Do not install backwards or short circuit the batteries.
• Do not attempt to dismantle or charge the batteries. Keep
away from fire.
• Always replace the screws in the remote control.
• Follow battery manufacturers' instructions when installing
new batteries (battery type CR 2032).
• Limited functionality is available without the remote control
(see 'Control without the remote').
Automatic cut-out
• If the appliance is tilted by over 5° the display will show
a 'tilted' graphic. If after 15 minutes the appliance is not
levelled it will switch 'OFF'.
• If the appliance has been tilted make sure it is level and
clear up any spillage.
Troubleshooting
• Do not carry out any maintenance or repair work other
than that shown in this Dyson Operating Manual, or
advised by the Dyson Helpline.
• An F3 failure message means the appliance is too cold. The
appliance will operate when it is above 5°C (41°F). If other
failure messages are displayed, contact the Dyson Helpline.
• For F1, F2, F4 and F5 error messages, turn the appliance
into standby mode/ "OFF". Unplug from the mains
electricity supply. Wait 30 seconds. Plug the appliance
back in and switch "ON" . If error persists, please call the
Dyson Helpline.
• If the UV-C emitter is exposed for any reason the appliance
will switch 'OFF'.
• If the piezo or UV-C emitter needs to be replaced, contact
the Dyson Helpline.
Disposal information
• Dyson products are made from high grade recyclable
materials. Recycle where possible.
• The battery should be removed from the product
before disposal.
• Dispose of or recycle the battery in accordance with local
ordinances or regulations.
To help us ensure you receive prompt and efficient service,
please register as a Dyson appliance owner. There are three
ways to do this:
• Online at www.dyson.com/register (UK) or
www.dyson.ie/register (ROI).
• Telephone the Dyson Helpline on 0800 298 0298 (UK) or
01 475 7109 (ROI).
• Complete the enclosed form and post it to us.
This will confirm ownership of your Dyson appliance in the
event of an insurance loss, and enable us to contact you if
necessary.
LIMITED 2 YEAR GUARANTEE
TERMS AND CONDITIONS OF THE DYSON 2 YEAR
LIMITED GUARANTEE
What is covered
• The repair or replacement of your Dyson appliance (at
Dyson's discretion) if it is found to be defective due to
faulty materials, workmanship or function within 2 years of
purchase or delivery (if any part is no longer available or
out of manufacture Dyson will replace it with a functional
replacement part).
• Where this appliance is sold outside of the EU, this
guarantee will only be valid if the appliance is used in the
country in which it was sold.
• Where this appliance is sold within the EU, this guarantee
will only be valid (i) if the appliance is used in the country in
which it was sold or (ii) if the appliance is used in Austria,
Belgium, France, Germany, Ireland, Italy, Netherlands,
Spain or the United Kingdom and the same model as
this appliance is sold at the same voltage rating in the
relevant country.
WHAT IS NOT COVERED
Dyson does not guarantee the repair or replacement of a
product where a defect is the result of:
• Accidental damage, faults caused by negligent use or
care, misuse, neglect, careless operation or handling of
the appliance which is not in accordance with the Dyson
Operating Manual.
• Use of the appliance for anything other than normal
domestic household purposes.
• Use of parts not assembled or installed in accordance with
the instructions of Dyson.
• Use of parts and accessories which are not genuine
Dyson components.
• Faulty installation (except where installed by Dyson).
• Repairs or alterations carried out by parties other than
Dyson or its authorised agents.