Cleaning The Ploughshare; Cleaning The Work Vehicle - Checchi & Magli BABY TRIUM Serie Manual De Uso Y Mantenimiento

Cleaning the ploughshare

Clean the ploughshare to remove any debris, mud, peat,
plant residues etc that may have built up during use.
B
UN41-0724EO
For this operation, proceed as outlined below.
1) Lift the work vehicle off the ground.
2) Move lever (A) and turn the guide (B) downwards, if
the skid is fitted.
3) Loosen the wing nut (C).
4) Turn the lock lever (D).
5) Push the share forwards and turn it so it is facing
downwards.
6) Clean the ploughshare with the tool provided (E).
Tyre check
Check the tyres for wear and if they feature tears or signs
of ageing, they must be replaced.
Check and if necessary restore the tyre pressure (see the
"Technical characteristics" table).

Cleaning the work vehicle

Clean the work vehicle with a high-pressure water jet
and, if necessary, with approved detergents.
The liquid used for washing could be hazardous for the
environment due to the presence of pollutants such as
detergents, oils, etc., therefore do not simply dump the
English language
MAINTENANCE INFORMATION
NOTICE
Lack of cleaning will limit the ejector range, there-
fore, as well as affecting the machine's operation, it
also causes serious mechanical damage.
F
C
7) Once the cleaning is complete, replace the plough-
share in the working position and check that the lock
lever (D) is holding it in position.
8) Tighten the wing bolt (C).
9) Turn the guide upwards (if the skid is fitted) and se-
cure it in position with lever (A).
NOTICE
Check that the Plant Control device is inside the
share.
The pressure must be checked with the work vehicle
resting entirely on the ground and with nothing and no-
body on the vehicle (people or things).
wastewater; dispose of it in suitable areas equipped with
separation devices for the pollutants.
Dry with compressed air and lubricate the components
shown (see "Lubrication diagram").
39
7
E
Use and maintenance