Harbor Breeze SARATOGA 00798 Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
7. Connect BLACK wire from fan to BLACK wire from
ceiling. Connect WHITE wire from fan to WHITE
wire from ceiling. Connect all GROUNDED
(GREEN) wires together from fan to GREEN/
GROUNDED wire from ceiling. Connecting the
GREEN/GROUNDED wires is conducive to receive
the signal of the remote control.
Note: BLACK wire is hot power for fan and light kit.
WHITE wire is common for fan and light kit. GREEN
wire is grounded wire. lf house wires are different
colors than referred to above, stop immediately and
consult a professional electrician to determine
proper wiring.
8. Twist wire ends together and screw wire connectors (AA)
on in a clockwise direction. Tape wire connectors (AA)
and wires together with electrical tape (not included).
Note: Wires should be spread apart with grounded
conductor and equipment-grounding conductor on one
side of outlet box and ungrounded conductor on other
side. After making connections, make sure bare wire or
wire strands are NOT visible. Place green and white
connections on opposite side of box from black and blue
connections. Splices should be turned upward and
pushed carefully up into outlet box.
Hardware Used
Wire Connector
AA
Wire connector
9. Slide canopy (B) up against ceiling and over two screws
on mounting bracket (A). Rotate canopy (B) to lock it
into place. Tighten two screws.
7
Supply circuit
Grounded/Green
White
White
Black
Black
Grounded/
Green
8
AA
x4
9
B
8
ASSEMBLY INSTRUCTIONS
10. Slide canopy cover (C) over two screws and rotate
clockwise until it locks.
Note: Adjust screws as necessary until canopy (B) and
canopy cover (C) are snug.
Outlet box
outlet box
Green/
GREEN/
Grounded GROUNDED
Receiver receiver
11. Attach blade (G) under blade arm (F) using three
decorative screws (CC) and three blade screws (DD).
Repeat for remaining blades (G), blade arms (F),
decorative screws (CC) and blade screws (DD).
Hardware Used
CC Decorative Screw
DD Blade Screw
12. Insert blade assembly through slot on fan motor
assembly (H) and align three screw holes in blade
arm (F) with screw holes in fan motor assembly (H).
A Secure with three blade arm screws (BB). Repeat
for remaining blade assemblies.
Screws
Hardware Used
Blade Arm Screw
BB
10
11
DD
F
x 15
x 16
CC
12
slot
Slot
F
x 16
BB
9
C
G
H