Installing Appliance In Enclosure - Signature Kitchen Suite SKSFD3604P Guia De Instalacion

Installing Appliance in Enclosure

WARNING
Use 2 or more people when installing the appliance. Take care when moving the appliance. It
is very heavy and prone to tipping when not secured.
CAUTION
Take care to avoid damaging the water line or power cord when moving the appliance into the
enclosure.
Use an appliance dolly to move the unit near the opening.
placement. Once the unit is placed in front of the opening, completely retract the front leveling
legs to allow the unit to be rolled into position. Front and rear leveling legs can be adjusted
from the front once the unit is positioned.
If the unit has been on its back it must stand upright for a minimum of 24 hours before turning
on the power.
After the appliance is rolled into position, verify that the anti-tip brackets are properly engaged.
1. Remove the base panel.
2. Retract the leveling legs so the appliance
can be wheeled forward.
rear of the appliance until it emerges from
the hole at the front of the appliance.
5. Tie a long string around the middle of the
power cord. Feed the string over the top of
the appliance, pull it until the power cord
is held high off the ground, then tape the
string to the front of the appliance to hold
or strain the power cord. Make sure it is still
plugged in.
6. Carefully move the appliance into the
enclosure, making sure not to pinch the
power cord or water line under or behind the
appliance.
7. Remove the edge protection on the
enclosure.
1
5
2
4
3
5
6
19