Introduction
Engine
Never use open flames for any reason.
Never leave open containers or containers not suitable for holding fuel in passageways,
close to heat
sources, etc
Never use petrol to clean the vehicle or the floor of the workshop. Always use low flash
point solvents to clean the vehicle components.
Never suck from or blow into the fuel pipe.
When welding, make sure that there are no flammable liquids in the vicinity. Always re-
move the tank, even if completely empty, and disconnect the negative cable (-) from the
battery.
Never leave the engine running in closed or poorly ventilated areas.
Before any servicing, make sure that the motorbike is perfectly stable.
The front wheel should preferably be anchored to the equipment (A/F-4) integral with the
lifting board.
F-4
9