Power Supply Connections - MBM WGG74 Manual De Uso E Instalación

tion and environmental limit conditions
permitted), previously made suitable,
of the appliance.
The tasks of levelling and securing in-
clude: adjustment of the appliance as
a single independent unit.
Place a spirit level on the structure
(detail D).
Adjust the levelling feet (detail E) ac-
cording to the indications provided by
the level.
Perfect levelling is achieved by
adjusting level and feet on the wi-
dth and depth of the appliance.
"SERIES" ASSEMBLY / see SECT.
IMAGES - REF. d).
Remove the knobs and unscrew the
screws for the fixing of the panel on
both appliances (detail F).
Flammable walls / The minimum
distance of the appliance from
the side walls must be 10 cm
and from the rear wall must be 20 cm.
If it is lower, insulate the walls close to
the appliance with fireproof and / or in-
sulating treatments.
Install the appliances so as to
exclude any accidental contact
Before proceeding with the
operations, see "General sa-
fety information".
These operations must be per-
formed by qualified and au-
thorised operators, in accord-
ance with the laws in force and using
the appropriate materials described.
Generally, the appliance is
delivered
mains supply cable, without
pipes for connection to the water,
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
POSITIONING AND HANDLING

POWER SUPPLY CONNECTIONS

without electric
- 10 -
with high temperature surfaces,
including hot combustion fumes coming
out of the chimney (see identification
with High temperatures warning label
and description on page 2), to people
who transit and / or operate within the
work environment.
To place the equipment adherent each
other perfectly (part G). Level the equi-
pment as described above (detail E).
Remove the protective caps (part H2).
Insert the screws in their housings and
lock the two structures with the locking
nuts (part H1-H3).
Replace the protective caps between
the devices (part H2).
Repeat, if necessary, the sequence of
leveling and fixing operations for the
remaining equipment.
INTRODUCTION OF TERMINAL (OP-
TIONAL) see SECT. IMAGES - REF.
d). / In order to introduce the terminal,
position it and fix it with the equipped
screws provided (detail L1).
Once the described operations have
been carried out, position again the pa-
nels and knobs of the different applian-
ces in the respective housings.
drainage and gas networks.
GASPOWER CONNECTIONS -
see SECT. IMAGES - REF. e).
Features of the installation site /
The premises for installation of the ap-
pliance (type A1 under hood) must be
equipped with features such as:
Air premises according to the provi-
sions required by the local regulations
in force. The extraction hood above
the appliance must be in operation du-
ring use of the appliance itself.
4.