Husqvarna 525HE3 Manual Del Usuario página 13

WARNING:
product with a damaged spark plug
cap to prevent electrical shock.
To prepare a warm engine for start
1. Push the air purge bulb again and again
until fuel starts to fill the bulb. It is not
necessary to fill the air purge bulb fully.
2. Pull the starter rope handle until the engine
starts. Push the throttle trigger slowly to
increase the speed gradually.
CAUTION:
starter rope to full extension. Do
not let go of the starter rope
handle when the starter rope is
fully extended. This can cause
damage to the product.
To stop the product
1. Move the stop switch into the stop position
to stop the engine.
1173 - 001 -
Do not use the
Do not pull the
CAUTION:
automatically goes back to its
initial position. In order to prevent
accidental starting, the spark plug
cap must be removed from the
spark plug when assembling,
checking and/or maintenance is
done.
To operate the product
• Start near the ground and move the
product up along the hedge when you cut
the sides.
• Make sure that the engine does not touch
the hedge.
• Hold the product near your body for a
stable work position.
• Make sure that the cutting unit does not
touch the ground.
• Be careful and work slowly until all the
branches are correctly cut.
To adjust the angle of the cutting unit
The cutting unit can be adjusted in 10 different
positions.
The stop switch
13