• Do not put warm objects near the fuel or
the engine.
• Do not add the fuel when the engine is on.
• Make sure that the engine is cool before
you refuel.
• Before you refuel, open the fuel tank cap
slowly and release the pressure carefully.
• Make sure there are sufficient airflow when
refueling and mixing fuel (petrol and two-
stroke oil) or draining the fuel tank.
• Fuel and fuel vapor are highly flammable
and can cause serious injury when inhaled
or allowed to come into contact with the
skin. For this reason, observe caution when
handling fuel and make sure there is
sufficient airflow.
• Tighten the fuel tank cap carefully or a fire
can occur.
• Move the product at a minimum of 3 m (10
ft) from the position where you filled the
tank before a start.
• Do not put too much fuel in the fuel tank.
• Make sure that a leak cannot occur when
you move the product or fuel container.
• Do not put the product or a fuel container
where there is an open flame, spark or pilot
light. Make sure that the storage area does
not contain an open flame.
• Only use approved containers when you
move the fuel or put the fuel into storage.
• Empty the fuel tank before long-term
storage. Obey the local law on where to
dispose fuel.
• Clean the product before long-term
storage.
• Remove the spark plug cap before you put
the product into storage to make sure that
the engine does not start accidentally.
Introduction
This section describes how to assemble and
adjust the product.
WARNING:
the product, read the safety chapter
and the assembly instructions.
1173 - 001 -
Assembly
Before you assemble
Safety instructions for maintenance
WARNING:
instructions that follow before you
use the product.
• Stop the engine and make sure that the
cutting equipment stops. Let the product
become cool before you do the
maintenance.
• Disconnect the spark plug cap before you
do the maintenance.
• The exhaust fumes from the engine contain
carbon monoxide, an odourless, poisonous
and very dangerous gas that can cause
death. Do not run the product indoors or in
closed spaces.
• The exhaust fumes from the engine are hot
and can contain sparks. Do not run the
product indoors or near flammable material.
• Accessories and changes to the product
that are not approved by the manufacturer,
can cause serious injury or death. Do not
change the product. Always use original
accessories.
• If the maintenance is not done correctly
and regularly, there is an increased risk of
injury and damage to the product.
• Only do the maintenance as this operator's
manual recommends. Let an approved
Husqvarna service agent do all other
servicing.
• Let an approved Husqvarna service agent
do servicing on the product regularly.
• Replace damaged, worn or broken parts.
Read the warning
9