Burner Description; Burner Equipment; Accessories - Riello BG5 Instrucciones De Instalación, Uso Y Mantenimiento

1.

BURNER DESCRIPTION

One stage light oil burner with low pollutant emissions (Nitric Oxide NOx, Carbon monoxide CO and unburnt
Hydrocarbons). The burner has a device (compensator) which is integral with the air damper that sets the air
output. This device keeps the oxigen level as necessary for the combustion despite any changing of the
room temperature.
The dimension of the boiler's combustion chamber must respond to specific values, in order to guarantee a
combustion with the lowest polluting emissions rate.
Technical Service Personnel will be glad to give you all the imformation for a correct matching of
The RIELLO
this burner to the boiler.
CE Certification No.: 0036 0268/99 as 92/42/EEC.
The burner meets protection level of IP X0D (IP 40), EN 60529
Burner with CE marking in conformity with EEC directives: EMC 89/336/EEC - 2004/108/EC, Low Volt-
age 73/23/EEC - 2006/95/EC, Machines 98/37/EEC and Efficiency 92/42/EEC.
Fig. 1
1 – Oil pump
2 – Control-box
3 – Reset button with lock-out lamp
4 – Air damper adjustment assembly
5 – Nozzle holder assembly
1.1

BURNER EQUIPMENT

Flange with insulating gasket . . . . No. 1
Screw and nuts for flange . . . . . . No. 1
Remote reset connection . . . . . . No. 1
1.2

ACCESSORIES

DIAGNOSTIC SOFTWARE KIT
A special kit is available that detects the life of the burner through optical connections with a PC showing
the duty hours, number and types of lockout, control box serial number etc...
Do the following to display the diagnostic:
Connect the kit supplied separately to the appropriate socket on the control box.
The information is read after the software program in the kit is booted.
REMOTE RESET KIT
The burner is fitted with a remote reset kit (RS) consisting of a connection to which a button can be con-
nected up to a distance of 20 meters.
For the installation, remove the protection block installed in the factory and install the block that is supplied
with the burner (see wiring diagram on page 7).
3402
2
D8012
5
1
6 – Flame detector
7 – Hydraulic jack
8 – Temperature probe of the compensator
9 – Start delaying device
Screw and nuts for flange to be fixed to boiler . . . No. 4
Flexible oil pipes with nipples . . . . . . . . . . . . . . . . No. 2
2 GB
3 6 4
7
8
9