Preparation For Storage - Imer Group JARD 7 EX Manual De Usuario

NOTE
Use only genuine parts.
9.4. SERVICING THE FUEL FILTER
CLEANING THE FUEL FILTER
Clean the fuel filter every 100 operating hours.
REPLACING THE FUEL FILTER
Replace the fuel filter every 1000 operating hours.
NOTE
This operation should be performed by the dealer of by the nearest After Sales Service.
9.5. REPLACING THE FUEL PIPE
•
Replace the fuel pipes every 2 years or every 1000 operating hours.
•
In case a leak is detected on fuel pipes, replace them at once.
NOTE
This operation should be performed by the dealer of by the nearest After Sales Service.
9.6. INSPECTION OF BOLTS, SCREWS AND NUTS
•
Tighten bolts and nuts when they are loose.
•
Make sure there is no oil leak.
•
Make sure there is no water leak on hydraulic fittings.

10. PREPARATION FOR STORAGE

□ There must be no water left in the pump for long periods of time. Deposits or minerals can settle
down on parts of the pump and damage it.
The following procedure must be followed before the pump set is stored for a period of 30 days or
more:
1. Drain the water circuit (see 10.1.);
2. Replace used oil with new oil (see 9.1.);
WARNING
F
EN
E
R
39