Lea LE71087-40 Manual Original página 17

ignition plug.
6. Cover the water pump in order to protect it against dust.
11.TROUBLESHOOTING
11.1The motor does not start
Check the following possible causes:
1. The fuel is not sufficient.
2. Ensure that the fuel lever is switched on. ON.
3. Ensure that petrol reaches the carburettor.
If the fuel lever is set to "ON", check by removing the drain plug which is below the carburettor.
ATTENTION: The petrol is highly combustible and explosive under certain
circumstances.
ATTENTION: If fuel leaks or is distributed, it must be removed and dried before the
ignition plug is checked and the motor is ignited.
4. Ensure that the On/Off switch of the motor is set to the "ON" position.
5. Check if there is enough motor oil in the crank shaft.
6. Ensure that the ignition plug is in a good condition.
a. Remove the cap of the ignition plug, clean it and then take the ignition plug off.
b. Adjust the ignition plug in the cap.
c. Set the On/Off switch of the motor to the "ON" position.
d. Connect the electrode of the ignition plug with the motor.
e. If there is no spark, the ignition plug must be replaced.
7. If the motor still does not start, contact your authorised sales partner.
11.2 The pump does not pump water
Check the following possible causes:
1. Ensure that the water quantity is sufficient.
2. Check the filter for blockages and clogging.
3. Check if the fastening clamps of the hoses are sufficiently fixed.
4. Ensure that the suction hose is not damaged or perforated.
5. Ensure that the suction distance does not exceed the suction performance of the pump.
6. If the pump still is not able to pump, contact your authorised sales partner for further
assistance.
12.DISPOSAL OF WASTE MATERIALS
Accessories and packaging must be disposed of in an environmentally friendly
manner in order to allow for recycling. Recyclable plastic parts are labeled
accordingly.
13