Remote Control Procedures - Luminance Brands Kathy Ireland Home RIPTIDE CF605BQ00 El Manual Del Propietario

WARNING
!
Fan installation must be completed, including the
installation of the fan blades, before testing the remote
control.
7.3: Setting Operating
Frequency of Remote Control
Remove the Battery Cover by pressing firmly below
the arrow and sliding the Cover off the Control
(Figure 35) .
Your Remote Control has Code Switches which must
be set in one of 32 possible code combinations .
The five levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up) position . Change
the Switch settings as follows:
Slide the five Switch Levers in the Remote Control to your
choice of ON (up) or down positions . Use a ball-point
pen or small screwdriver and slide the Levers firmly up or
down (Figure 35) .
The sixth Switch marked ON and I is for dimming control
of lights: Set Switch to ON to allow for dimming of the
lights . Set Switch to I for no dimming of the lights .
NOTE: If your Fan and Light go on and off without
using your Control, you may be getting interference
from other remote units such as garage door
openers, car alarms or security systems.

7. Remote Control Procedures

Your Receiver is equipped with a preset memory feature .
If the AC supply to the Receiver is powered through a
Wall Switch, when the Switch is turned OFF, the Control
will remember the Light Intensity and Fan Speed .
When the Switch is turned back ON the Light and Fan
will resume operation as they were prior to the Switch
being turned OFF .
Figure 34
BATTERY
COMPARTMENT
COVER
Figure 35
To remedy this situations, simply change the
combination code in your Remote Control
Transmitter.
Please contact 1-800-777-4440 for further assistance
23
REMOTE CONTROL
LEVERS
ON
1 2 3 4 5
I
CODE
SWITCHES
REMOTE CONTROL
luminancebrands.com
U.L. Model No.: CF605