Metrohm 794 Basic Titrino Instrucciones Para El Uso página 114

3.2. Remote control commands
110
Parameters for TIP: Parameters of the elements of TIP.
.Method: Method name of a method available in the user memory. Up to 8
ASCII characters.
.Pause: Pause time in s. INF means infinite. Continue the sequence with
&m $G.
.L4 Output: Warning: A pulse triggered by the limit value monitoring at L4 (pin
3) in a submethod sets an output set to active in TIP to inactive.
.L6 Output: Warning: An activate pulse at L6 output (pin 1) in a submethod
sets an output set to active in TIP to inactive.
.Info: Entry of a message which is written into the display. The se-
quence remains in the display with the corresponding message.
Continue with &m $G.
3.2.2.44. Mode.Parameter.Presel.MeasMode
Mode.Parameter.Presel.MeasInput
Mode.Parameter.Presel.Ipol
Mode.Parameter.Presel.Upol
Mode.Parameter.Presel.PolElectrTest
Mode.Parameter.Presel.Temp
Parameters for TIP: Selection of the measured quantity for manual measure-
ments in the inactive state, see 3.2.2.2. Selection of the measuring input
(MeasInput) applies to measured quantities pH and U. "diff." means differen-
tial amplifier, see page 155. With Ipol the requests for the polarization current
in µA (Ipol) and .PolElectrTest apply. With Upol the request for the polarization
voltage in mV (Upol) applies. Entry in steps of 10 mV. .PolElectrTest also ap-
plies. If the test for polarized electrodes is switched on (ON), it will be per-
formed on the change from the inactive state to an active state. The tempera-
ture applies to pH measurements.
3.2.2.45. UserMeth.FreeMem
Memory space, available for user methods or silo lines. $Q sends the number
of free bytes, e.g. "4928".
3.2.2.46. UserMeth.Recall
UserMeth.Recall.Name
UserMeth.Store
UserMeth.Store.Name
UserMeth.Delete
UserMeth.Delete.Name
UserMeth.DelAll
Management of the internal method memory: Load, store and delete methods.
An action is performed if "$G" is sent to the corresponding node just after en-
tering the name.
Do not use blank characters before and after method name!
.DelAll: Deletes all methods in the user memory.
3.2.2.47. UserMeth.List.1.Name
UserMeth.List.1.Mode
UserMeth.List.1.Quantity
pH, U, Ipol, Upol, OFF
1, 2, diff.
0...1...±127
0...400...±1270
ON, OFF
-170....25.0...500.0
read only
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
$G
up to 8 ASCII characters
$G
read only
read only
read only
794 Basic Titrino