Descargar Imprimir esta página

diversey TASKI swingo XP-M IntelliSweep Manual De Instrucciones página 86

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 93
• Press the suction unit ON/OFF button to lift
and stop them.
Notice:
For working with the lateral cleaning
brushes, it is required to check the accu-
mulated dirt at the front cleaning brushes
at regular intervals.
• For that purpose, move the machine back by two meters.
While doing so, the front and lateral cleaning brushes are
held and lifted.
A vibrator loosens the dirt from the front cleaning brushes.
Notice:
Do not switch off the machine.
• Clean up the dirt with the provided brush and shovel and
deposit it in the bucket attached to the front.
• Continue the cleaning process with the machine.
Position sensor
Notice:
This machine is equipped with an integrat-
ed position sensor that indicates the posi-
tion of the IntelliSweep protruding at the
right side of the machine.
• When cleaning near walls or other
obstacles, observe the position sen-
sor.
It helps you estimate the distance
from the wall or the obstacle more
accurately.
Cleaning start
• If the machine is switched on and the
operator is standing on the running
board, the machine starts moving as
soon as the driving switches are op-
erated. If selected, the brush unit and
lateral cleaning brushes are started
and the cleaning solution supply is
opened.
The speed is controlled by the posi-
tion of the driving switch. When the
driving switch is released, the ma-
chine is automatically decelerated
until it stops and the parking brake is
activated. The cleaning solvent sup-
ply is closed, and the brush unit and
lateral cleaning brushes are stopped
with some delay.
Notice:
The supply volume of the cleaning solution
is adjusted to the corresponding working
speed. (IntelliFlow)
84
Attention:
When working in heavily furnished or nar-
row zones, the slow approach ON/OFF
button must be pressed. (Display lights up)
The maximum working speed is reduced,
and thus so is the risk of accidents.
• Pressing this button once more will override
this restriction, and the display disappears.
• If the red display on the battery level indica-
tor lights up, you must drive the scrubber
dryer to the battery charger.
Battery capacity - end of operational readiness
The battery level indicator provides information on the avail-
able operating time.
• If the red indicator begins to flash, approx. 5 minutes of
residual working time are left.
• After this period, the brush unit and – 30 seconds later –
the squeegee is lifted. The red display switches to continu-
ous light.
• Now 10 more minutes remain for driving the machine to the
charging station. Then the machine is automatically
switched off.
• In order to restart, the batteries must be fully charged.
Cleaning method
Direct working method:
Scrubbing, dry cleaning, wet cleaning and suction in one work
step.
Indirect working method:
Applying the cleaning solution, scrubbing, dry cleaning and
suction in several work steps.
Notice:
The machine guiding might be impaired in
case of special combinations of flooring/
contamination and cleaning product.
Optionally available wheels can improve
the traction of the machine on the floor.
Please contact your TASKI customer con-
sultant.

Publicidad

loading