Configuring A New Sequence; Selecting A Sequence - Lorex L23WD800 Serie Manual Del Usuario

• The Sequence window opens:
Figure 11.4 Sequence window (blank).
7. Click ADD.
• The Sequence Setup window opens.

Configuring a New Sequence

With the new sequence added, you can now set
on-screen configurations and channels for the
sequence.
Figure 11.5 Sequence Setup (16-channel model shown).
To configure the new sequence:
1. Under VIEW TYPE, click a screen
configuration (single channel, quad,
6-split, 8-split, 9-split, 16-split) .
2. Under CONFIGURE, in the corresponding
channel, click to assign the channel
to the selected square on the grid.
Figure 11.6 Sequence Setup window. In this figure, channels
1, 8, 7, 3 are assigned to the quad-screen sequence.
3. Click CONFIRM.
• The customized configuration appears on
the previously blank Sequence window.
4. Click CLOSE to save your settings.
5. Repeat steps to add new sequences.
To edit an existing configuration,
NOTE:
double-click a grid icon in the Add Sequence
window.
Figure 11.7 Double-click a grid icon to edit the configuration.
6. Click APPLY to save your settings or select
CANCEL to restore defaults.
From live viewing, click DISP in the Status Bar
and then click the Auto Sequence
button ( ) to start the new sequence.

Selecting A Sequence

You can create up to 16 sequences but only one
can be active. The sequence with a checkmark
under "Activation" is the active sequence on
the system.
To change sequences:
1. Under LIST, double-click the name of the
sequence. you wish to activate.
• The EDIT window opens.
Figure 11.8 Edit sequence window.
Using the System Menu
Grid icon
57