The SW1 Dip-Switches allow you to select the 1 or 2 motor function
and define which of the two motors starts first and which second.
SW1
SW1
SW1
ON
ON
ON
1
2
1
2
1
2
1
NON PRIS
2
RETARD
2
RETARD
MOTEUR
MOTEURS
MOT. 2
MOTEURS
MOT. 1
EN COMPTE
DIP SWITCH SW2
The SW2 Dip-Switches allow to change the direction of stroke
of each motor without physically intervening on the electrical
connections in the terminal block.
SW2
SW2
SW2
ON
ON
ON
ON
1
2
1
2
1
2
1
INV
INV
INV
INV
INV
INV
INV
OFF
OFF
MOT 1
OFF
OFF
MOT 2
MOT 1
2 WIRES CONNECTION TABLE:
TAB.01
n°
DESCRIPTION
1
Power supply
6A
Motor power supply
2
Flashing light
4A, 5A
TX photocell
4B, 5B
RX photocell
6
Key selector
6B
Limit switches
6C
Encoder
3
Antenna
The table refers to the example of wiring shown in the ABACUS model manual for swing motors.
If the cables are of a different length than those shown in the table, the section of the cables must be determined based on the actual absorption of the connected
devices.
SW2
2
INV
MOT 2
CABLE
LENGTH from 1m to 20m
2 x 1.5 mm
2 x 2.5 mm
2 x 0.5 mm
EN standard 50575, in
the list of harmonized
2 x 0.5 mm
rules for the Regulation
4 x 0.5 mm
CPR 305/2011, Com.
2016/C 209/03
3 x 0.5 mm
3 x 0.5 mm
3 x 0.5 mm
RG58
TRIMMER SENS: It regulates the SENSITIVTY of motors
Turning with a screwdriver towards the + increases the speed of the
motor stroke during the slowing down phase
TRIMMER SPEED: It regulates the SPEED of motors
Turning with a screwdriver towards the + increases the motor speed
during the stroke.
TRIMMER SLOWING: It regulates the slowdown speed of motors
Turning with a screwdriver towards the + increases the sensitivity and
therefore the motor will block its stroke more quickly if an obstacle is