Comunello Automation QUAD Instrucciones De Uso Y Instalacion página 38

The third menu is the one defined as EXTENDED 2 and to access the programmable functions follow the instructions given in Tab. 4:
EXTENDED • Press the SELECT button and scroll the LED menu until you
MENU 2 reach the LEV LED;
• Press SET twice to access the EXTENDED menu 2.
LIVEL 2 - EXTENDED MENU 2
LED FUNCTION
L1 BRAKE Enabling of the electronic brake
L2 STEP BY STEP 1 Step-By-Step logic
L3 ALWAYS CLOSE Enables the sending of a CLOSE
command when the power is
turned on again
L4 FOLLOW ME The motor automatically closes in
5 sec after passing through DS1
photocell
L5 PEDESTRIAN TIME Storage of motor no.1 partial
stroke with slowdowns
L6 2°CH Setting the aux. relay of the
MONOSTABLE / 2°CH as Bistable / Monostable /
BISTABLE/TIMED Temporised monostable
MONO.
L7 REMOTELY Enable the remote control
PROGRAMMING memory function without acting
on the control unit
Table 4
The fourth and last menu is defined as EXTENDED 3 and to access the programmable functions follow the instructions given in Table 5:
EXTENDED • Press the SELECT button and scroll the LED menu until you
MENU 3 reach the LEV LED;
• Press SET 3 times to access the EXTENDED menu 3.
LIVEL 3 - EXTENDED MENU 3
LED FUNCTION
L1 SOFT STOP Setting of gradual slowdown at
the end of the movement
L2 SOFT START Setting of gradual slowdown at
the beginning of the movement
L3 RELEASE STROKE Before opening, the closing thrust
MAX FORCE/ is activated for the electric lock
RELEASE STROKE release
L4 SLAM LOCK MAX Activation of the push in closing
FORCE / SLAM for electric lock release
LOCK
L5 ELS / CMD PED Activation of the electric lock as
PPED input
L6 LAMP/INDICATOR Flashing light set as pilot light or
LIGHT/COURTESY courtesy light
LIGHT/
L7 PRELAMP / LAMP Activation of the pre-flashing of
IN PAUSE 3 sec. before closing / Flashing
during the pause time
Table 5
Note: The control unit allows to be programmed if all the safety devices (N.C. inputs on terminals) grant a contact closed.
38 COMUNELLO ®Copyright 2021 - All rights reserved
DESCRIPTION
Enabled function
Open-Stop-Close-Stop (It DOESN'T close after the pause time in a
partial opening phase)
Enabled function
Enabled function
Partial stroke of motor no.1 stored
Bistable command
Enabled function
DESCRIPTION
Enabled function
Enabled function
Active function
Active function
Enabled function
The courtesy light / warning light becomes an intermittent output, while
the lamp output becomes a courtesy light"
Active function: preflash in closing / Flash during pause
time
The LED of the LEV function FLASHES with this frequency
LED ON
Disabled function
Disabled function
Disabled function
Disabled function
Monostable command (impulsive)
Disabled function
The LED of the LEV function FLASHES with this frequency:
LED ON
Disabled function
Disabled function
Disabled function
Disabled function
Disabled function
Flashing light
Disabled function
LED OFF DEFAULT
10 sec., without slowdowns
LED OFF DEFAULT