Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
!
WARNING
NOTE
Remove for
pressure range
0.3 to 1 bar
Dimensions: mm (inch)
12
Nothing herein should be construed as a warranty regarding the
specific properties or results that can be expected from any
specific application of Testomat 2000
Warranty conditions, please consult the Gebrüder Heyl
Analysentechnik GmbH Limited Warranty.
Installation
Risks resulting from incorrect installation!
(Risk of personal injuries due to electric shock and instrument
malfunctioning).
Install Testomat 2000
dripping or splash water, dust and aggressive substances – e.g. in
a switch cabinet or on a suitable wall.
Information for trouble-free operation
(Malfunctioning and incorrect evaluation of the instrument possible).
Install Testomat 2000
Install Testomat 2000
Operating Testomat 2000
range of 0.3 to 1 bar
Prior to installation, please check whether lower operating pressure is
required. The instrument is factory set for the operating range of 1 to
8 bar. Remove the flow controller valve body
instrument in the operating range of 0.3 to 1 bar (e.g. when using an
aerator type R). This involves removing the retaining pin
controller/filter receiver
remove the controller plug
flow controller valve body
retaining pin.
Installing Testomat 2000
Select an installation site where the water inlet hose can be kept as
short as possible (max. 5 m).
Please leave sufficient space on the left-hand side of the
instrument to open the door.
Drill the mounting holes as shown in the drawing on the left.
Use three screws to attach the instrument at a suitable position in
the switch cabinet or on a wall.
®
. For specific Limited
®
at a location where it is protected against
®
vertically and without mechanical stress.
®
at a vibration-free site.
®
in the pressure
. Subsequently use the metal bracket to
from the borehole. Then remove the
and reinsert the controller plug and the
®
to operate the
from the
Publicidad
Tabla de contenido
