Instrument Settings - Heyl Testomat 2000 Instrucciones De Operación

Instrument settings

Caution!
Your settings may be deleted if repairs are carried out. Therefore, note down your instrument settings in the table below before
sending the instrument to our service team for repairs. Please enclose a copy of the table with the instrument. If you have noted
down the settings, they can be easily re-entered by your service staff once any repairs have been completed.
Menu
MODE OF OPERATION
Time-controlled
Volume interval
Dynamics
External (Start)
DISPLAY UNIT
Display in °dH
Display in °f
Display in ppm CaCO
3
Display in mmol/l
TYPE OF REAGENT
500ml-bottle
100ml-bottle
TH2005 Water hard.
TH2025 Water hard.
TH2100 Water hard.
TH2250 Water hard.
TC2050 Carbon. hardn.
TC2100 Carbon. hardn.
TM2005 minus-m-value
TP2100 p-value
LIMIT VALUES
Limit val. 1:
Limit val. 2:
FLUSH TIMES/INTERVAL
Internal flush time
External flush time
Interval pause
MEASURING POINTS
1 Measuring point
2 Measuring points
TYPE OF WATER METER
1 Litre/Impulse
2,5 Litres/Impulse
5 Litres/Impulse
10 Litres/Impulse
100 Litres/Impulse
500 Litres/Impulse
1000 Litres/Impulse
LOCK OUT
Off
Limit val. 1:
Limit val. 2:
PLANT CONTROL
Min. Res. Quant.
Limit val. 1:
Limit val. 2:
BOB-OPERATION
Function off
Function on
BOB-duration
FUNCTION LV1
Setting Duration
Impulse
Interval
Two point
Time:
FUNCTION LV2
Duration
Impulse
Interval
Time:
HYSTERESIS LV1
Analysis (1,2,3)
HYSTERESIS LV2
Analysis (1,2,3)
ALARM/MESSAGE
Reagent low level
Low water pressure
Mf. analysis
Ff. optics
Ff. dosing fault
Ff. dosing pump
Ff. outlet to drain
Mf. dirtiness
power failure 24 V
Mf. turbid
Plant control
Transfer error
Meas. range exceeded
Maint. int. exceeded
FUNCTION IN1
Normally open contact
Normally closed contact
FUNCTION STOP
Normally open contact
Normally closed contact
INTERFACES
Type 0-20 mA
Type 4-20 mA
Type RS232
FUNCTION AUX
Contact before analysis
Contact during analysis
Contact after analysis
Time:
OPERATING TIME
MAINTENANCE INTERV.
CUSTOMER SERVICE