Installation; Operation; Cleaning; After Switch-Off And Longer Downtime - Heyl Testomat 2000 Instrucciones De Operación

Pay particular attention to
!
WARNING
NOTE
8

Installation

 Always completely disconnect the relevant plant part before
installing the instrument or connecting/disconnecting it to/from the
power supply. Secure the plant against reconnection.
 Only connect the instrument to the mains voltage specified on the
rating plate.
 Always observe technical data and ambient parameters.
 Testomat 2000
®
requires an interference free and stable power
supply. If necessary, use a mains filter to protect Testomat 2000
against interference voltages caused, e.g., by solenoid valves or
large motors. Never lay connecting cables parallel to power cables.

Operation

 Ensure that the maximum electrical load capacity of the relay
outputs is never exceeded.
 Immediately switch off Testomat 2000
malfunctioning occurs. The warranty will be void if you tamper with
or attempt to repair Testomat 2000
by authorized service staff.

Cleaning

 Only use a dry, lint-free cloth for cleaning.

After switch-off and longer downtime

 Ventilate the indicator leads as described in the start-up, because
longer downtimes (more than 6 hours) can cause the indicator in
the leads to retract.
 Do not switch off the appliance for longer periods (e.g. over the
weekend) via the start/stop output. The indicator can retract from
the leads. This results in measurement errors after the appliance is
switched on.

De-installation

 Prior to de-installing a defective instrument, always write down a
description of the error (failure effect). It is only possible to repair a
defective instrument (irrespective of the warranty period) if it has
been de-installed and returned to us with a description of the error.

Disposal

 Dispose of the instrument in accordance with national regulations.
®
and contact service staff if
®
. Repairs must be carried out
®