Turning The Camera On/Off; Scan Mode - miniland baby Digital Camera Plus Manual Del Usuario

3. Plug in the adapter to the mains.
Warning: Danger of Strangulation – Keep the cable out of reach of the baby. NEVER place
a camera with cables less than 1 metre away from the cot. Never use extension cables
with AC adapters. Only use the AC adapters supplied.
5.2. OPERATION

5.2.1. TURNING THE CAMERA ON/OFF

To turn the camera on or off, keep the on button (III) pressed in for two seconds. The power
LED (IX) will go on and off depending on whether you turn the unit on or off.
When you have installed the camera and turned it on, you can see the images and listen to the
sounds captured in your baby's room via the monitor.
5.2.2. INFRARED NIGHT VISION (AUTOMATIC)
The infrared night vision function enables the camera to capture images of your baby or of the
monitored area when it is dark or there is little light.
In this mode images will only be shown on the monitor in black and white and you will only be
able to see images situated less than 2 meters away.
The camera constantly monitors the light level and automatically switches to infrared mode when
there is not enough light for normal vision.
5.2.3. CHOOSING THE CAMERA
This product is designed to allow the observation of different areas with up to 4 cameras.
To choose the camera you want to see, follow the next steps:
1. Press for 3 seconds the Menu/Back
2. Press the UP
key enter into the sub-menu.
3. Press the UP
press the key.
4. Press the UP
the selection with the
Note 1: You will only be able to select the cameras that have already been paired with the
monitor.
Note 2: There is a faster way to change the camera you are viewing. Directly press
cycle through paired cameras: CAM1 / CAM2 / CAM3 / CAM4 / SCAN MODE.

5.2.4. SCAN MODE

This function automatically cycles through your paired camera channels to display each camera
for 12 seconds. This function can be used only when you have more than 1 camera unit paired.
To enter in this mode:
1. Press for 3 seconds the Menu/Back
2. Press the UP
key enter into the sub-menu.
3. Press the UP
press the key.
4. Press the UP
5. Press the key to confirm.
key or DOWN key until the camera icon
key or DOWN key until the SEE camera icon
key or DOWN key to select the camera that you want to see and confirm
key.
key or DOWN key until the camera icon
key or DOWN key until the SEE camera icon
key or DOWN key and select the SCAN icon
button and the menu will pop up;
key and the menu will pop up.
17
ENGLISH
is highlighted then press the
is highlighted and then
is highlighted then press the
is highlighted and then
.
key to