Zeizz VISULAS YAG III Instrucciones Para El Uso página 134

Maintenance / Miscellaneous
Message
Monitoring disabled, for service
purpose only!
Applicator LINK is selected, are you
sure?
Applicator LIO is selected, are you
sure?
Error 15
In the STANDBY and READY modes,
during YAG operation, demo is
displayed beside the aiming beam
button. The laser cannot be fired.
In the STANDBY and READY modes,
during 532s operation, demo is
displayed beside the aiming beam
button. The laser cannot be fired.
000000-1354-664 VISULAS YAG III 15.08.2005
Remedy
You are in a special service mode. All error messages are deactivated. Please
contact our service department. Patients must not be treated in this mode!
Safety question, to check that the correct applicator has been selected.
tick
Confirm by touching the
Safety question, to check that the correct applicator has been selected.
tick
Confirm by touching the
A button has been pressed for more than 5 s.
Release the button and continue with the ARROW button.
Switch the VISULAS YAG III off and then on again. While the progress bar is active
during the YAG III system test, touch the ZEISS logo on the screen, then press the
control knob/button.
Switch to STANDBY mode, touch the demo button for more than 5 seconds.
cross
, or abort by touching the
cross
, or abort by touching the
59
.
.