Promaker PRO-SB1800 Manual Del Usuario página 12

TO REMOVE / REPLACE THE
TABLE INSERTION
See Figure 10.
• Lower the blade by turning the
height / bevel adjusting wheel
to the left.
• Remove the worn insert from the
table.
TO TO CHANGE THE POSITIONS
OF THE DIVIDER KNIFE
See Figure 11.
This saw is supplied with a dividing
knife which should be placed in the
down position for grooving and in the
up position when full cuts of material
are required for the work of this saw.
• Unplug the saw.
To place in the "up" position for
the entire cut:
• Remove the insert from the table.
• Raise the saw blade by turning the
bevel / height adjustment wheel to
the right.
• Unlock the release lever by pulling
it up.
• Hold the dividing knife and pull it to
the right side of the saw to release
the dividing knife from the spring-
loaded divider clamp.
• Pull the dividing knife upward until
the internal pins are engaged and
the dividing knife is above the saw
blade.
• Lock the release lever by pushing
the lever down.
• Reinstall the table insert.
To place the riving knife in the
"down" position for grooved cuts:
• Remove the insert from the table.
• Raise the saw blade by turning the
bevel / height adjustment wheel to the
right.
12