Promaker PRO-SB1800 Manual Del Usuario página 5

PROVIDE ADEQUATE SUPPORT to
the rear and sides of the saw table for
wide or long workpieces.
• AVOID KICKBACK (workpieces
thrown at you) by:
a) Keep the blade sharp
b) Keep the cutting guide parallel to the
saw blade.
c) Keep riving knife, anti-kickback
pawls, and blade guard in place and
operating.
d) Do not release the work before it is
pushed past the saw blade using a
push rod.
e) Do not cut the workpiece that is
crooked, warped or does not have a
straight edge to guide along the guide.
DANGER!
Rolling the Cutting Tool Can Be Dangerous.
Apply the brake immediately to stop the
cutting tool when the switch is turned off.
• IF THE POWER SUPPLY CORD
IS DAMAGED, it must be replaced
only by the manufacturer or an
authorized service center to avoid
risks.
• AVOID
OPERATIONS
POSITIONS
could cause your hand to move in the
cutting tool.
• USE THE ONLY RECOMMENDED
ACCESSORIES mentioned in this
manual or appendices. The use of
accessories that are not listed may
cause the risk of personal injury.
Instructions for the safe use of
accessories are included with the
accessory.
UNCOMFORTABLE
AND HAND
where a sudden slip
• MAKE SURE THE WORK AREA
IS BRIGHTLY LIGHTED to view the
work piece and that no obstructions
interfere with
BEFORE performing any work using
the table saw.
• ALWAYS TURN THE SAW
before unplugging to avoid accidental
starting when plugged in again
• USE ONLY SHEETS
thickness range stamped on the saw
blade and in the instruction manual.
• THIS TOOL must have the following
warnings:
a) Wear eye protection.
b) Use the saw blade guard and
dividing knife for every operation for
which it can be used, including all
sawing through the workpiece.
c) Keep your hands out of the line of
the saw blade.
d) Use a dipstick when necessary.
• push
• e) Pay particular attention to the
instructions to reduce the risk of
kickback.
• f) Do not perform any free hand
operation.
• g) Never work around or on the saw
blade.
• h) Never operate the saw on the
ground or below waist height.
• NEVER CUT MORE THAN ONE
PIECE OF MATERIAL AT A TIME.
• SAVE THESE
Refer to them frequently and use
them to educate
you loan someone this tool, loan
them these instructions as well.
safe operation
OFF
within the
INSTRUCTIONS.
other users. If
5