Promaker PRO-SB1800 Manual Del Usuario página 13

• Hold the dividing knife and pull it to
the right side of the saw to release
the dividing knife from the spring-
loaded
• Push the dividing knife down until it
is at the same height as the saw
blade.
Lock the release lever by pushing
the
• Reinstall the table insert.
CHECK SAW BLADE INSTALLATION
See Figure 12.
NOTICE: For proper operation, the
saw blade teeth must point down
toward the front of the saw. Failure to
do so could cause damage to the saw
blade, saw, or workpiece.
• Unplug the saw.
• Lower the saw blade and remove the
insert from the table.
divider clamp.
lever down.
• Make sure the bevel lock lever is
pushed all the way to the
right.Raise the saw blade to its full
height by turning the bevel / height
adjusting wheel clockwise.
• Place rthe dividing knife in the "up"
position.
To loosen the saw blade:
• Insert the closed end wrench into
the saw blade washer.
• Insert the key of the closed end
saw blade over the disc nut.
Holding both keys firmly, pull the
closed end key toward the front of
the machine.
• To tighten the blade:
• Insert the closed end wrench into
the washer on the saw blade.
• Insert the closed end saw blade
wrench over
nut.Holding both keys firmly, push
the closed end key toward the rear
of the machine.Make sure the nut
on the saw blade is tight. Don't
over-tighten it.
• Reinstall the table insert.
• Check all clearances for free
rotation of saw blade
TO INSTALL THE BLADE GUARD AND
ANTI-KICKBACK RATCHETS
See Figure 13 - 15.
WARNING!
Replace blunt anti-kickback pawls
or damaged. Dull or damaged ratchets
may not stop kickback, increasing the
risk of serious personal injury.
the saw blade
13