Specific Safety Rules - Promaker PRO-SB1800 Manual Del Usuario

accidentally comes into contact.
CHECK FOR
Before using the tool, a guard or other
damaged part should be carefully
checked to determine if it will function
properly and perform its intended
function. Check
moving parts, bonding of moving parts,
breakage of parts, mounting, and any
other conditions that may affect their
operation. A guard or other part that is
damaged should
replaced by an authorized service
center to avoid the risk of personal
injury.
• USE THE CORRECT DIRECTION OF
PLACEMENT.
workpiece toward the blade or cutter
against the direction of rotation of the
blade or cutter.
• NEVER LET THE TOOL RUN
UNATTENDED.
POWER. Do not leave the tool until it
comes to a complete stop.
• PROTECT YOUR LUNGS. Wear a
face or dust mask if the cutting
operation is dusty.
• PROTECT YOUR
hearing protection during extended
periods of operation.
• DO NOT ABUSE THE CABLE. Never
yank the cord to disconnect it from the
power source. Keep the cord away from
heat, oil and sharp edges
• WHEN OPERATING AN OUTDOOR
POWER TOOL, USE AN EXTENSION
CORD MARKED "W-A" or "W". These
cables are designed for outdoor use
and reduce the risk of electric shock.
DAMAGED PARTS.
the alignment
be repaired
Just position
TURN OFF
EARS.
• KEEP BLADES CLEAN, SHARP,
AND IN SUFFICIENT PLACEMENT.
Sharp blades minimize stalling and
kickback.
• KEEP
CUTTING AREA. Keep your hands
of
away from the leaves. Do not try to grip
the workpiece under, around, or on the
blade while the blade is rotating. Do not
attempt to remove cut material when
blade is in motion.
or

SPECIFIC SAFETY RULES

the
• NEVER perform any "hands-free"
operation, which meant using only your
hands to
workpiece. Always use the cutter guide
or miter gauge to position and guide
the workpiece.
THE
• NEVER stand or have any part of
your body in line with the path of the
saw blade.
• NEVER reach behind, above, or
within three inches of the blade or
cutter with any hand for any reason.
Wear
• MOVE THE CUTTING GUIDE
out of the way when making a cross
section.
• DO
INDICATOR AND CUTTING GUIDE
during the same operation.
• NEVER attempt to free a jammed
blade from the saw without first turning
the saw off and disconnecting the saw
from the power source
HANDS AWAY
support or
NOT USE THE
FROM
guide the
MITER
4