Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Set-up and adjust weight distribution system per Reese
Installation Instructions for Weight Distribution. Reference
instruction sheet 66006IN for trunnion or 65590IN for round
bar styles.
3. Before placing snap-up in position, ensure that the cam of the cam arm is about 1/2" forward of the bend in the
spring bar, since the cam moves rearward as it is lifted by the snap-up bracket. After moving snap-up into the up
position, install safety pin. Use the metal tube supplied to assist in raising the snap-up bracket. Install second spring bar
position install safety pin Use the metal tube supplied to assist in raising the snap up bracket Install second spring bar
using the same number of chain links. Make sure that the cams are properly centered in the spring bar detent. If needed,
loosen the square head bolt slightly and tap the frame bracket until the cam and the detent are aligned. Use a block of
wood between the frame bracket and the hammer. Tighten the square head bolt ¼ turn after contacting the frame.
4. Raise the jack off the ground.
CAM ARM ADJUSTMENT:
1. Start out towing slowly in a straight line. Make an approximate 20° turn one way, then a 20° turn the other way.
Straighten out and drive approximately 100 ft. toward a distant point while sighting down the center of the hood.
2. Check mating of spring bar detent with cam arm. If not mated squarely, rap button of cam arm with hammer to
obtain alignment (see below).
g
(
WARNING!
KEEP HANDS AWAY FROM CAM ARM AND YOKE DURING THIS STEP BECAUSE
ALIGNMENT MAY OCCUR RAPIDLY AND WITHOUT WARNING, CREATING A DANGEROUS PINCH
POINT.
BUTTON
3. If the cam arm is not seated in the detent of the spring bar, slightly loosen the square head bolt from the frame plate and tap the
frame plate in the direction it needs to go so the cam and the spring bar detent are aligned. Place a small block of wood in front of
frame plate in the direction it needs to go so the cam and the spring bar detent are aligned. Place a small block of wood in front of
the frame bracket when adjusting its position. Lower the jack and remove some of the weight off of the spring bar. This will make
adjusting the frame plate easier. Tighten the square head bolt after adjusting the frame plates position. Repeat for the other side.
Spring bar detents and cams should be aligned at this time.
4. Raise the jack. The trailer and tow vehicle should be setting level at this time. If not, adjust the chain links on the snap-up bracket.
Re-check the cam arm alignment with the spring bar detent again. Adjust the frame bracket again if needed.
26002N
05MAY10K
)
HIT HERE WITH
NOTE: Set up and adjust weight
NOTE: Set-up and adjust weight
HAMMER
PCN12509
©2003 REESE PRODUCTS, INC
distribution system per Reese
Installation Instructions for Weight
Distribution. Reference instruction
sheet 66006IN for trunnion or
65590IN for round bar styles.
SPRING BAR DETENT
SEMI-CIRCULAR
CAM SURFACE
PRINTED IN XXXXXX
3
Publicidad
