Luminance Brands Kathy Ireland Home RAH ECO CF915TM60BS00 El Manual Del Propietario página 22

8. Wall Control Installation
8.5
Disconnect Electrical Power to the Branch Circuit at
the Circuit Breaker Panel or Main Fuse Box before
attempting to install the Ceiling Fan Wall Control into
the Wall Box.
Before installing the Second Wall Control, place the
Wall Control in "OFF" mode by pushing "ON/OFF"
) to the "OFF" ( O ) position.
Switch (
Install the Second Wall Control (purchased separately)
into the Wall Box containing the "LOAD" Wire.
Connect the Second Wall Control Black Wire labeled
"TO POWER SUPPLY" to the Traveler Wire(s) already
connected to the Black Wire (in the other wall box).
Secure with Wire Connectors, supplied (Figure 34).
Connect Second Wall Control Black Wire labeled
"TO FAN" to the "LOAD" (Black) Wire and secure with
Wire Connector, supplied (Figure 34).
Connect the Second Wall Control Green Ground
Wire to the Supply Ground Conductor (this may be
a bare wire or wire with Green Colored insulation).
Securely connect Wires with Wire Connector, supplied
(Figure 34).
Screw the Second Wall Control onto the Wall Box using
the supplied Screws. Leave the Wall Control in "OFF"
mode until Fan installation is completed.
NOTE: Retrofit 3-way installations are likely to
include two traveler wires between the two wall
boxes. In new construction, only one traveler wire Is
required (Figure 34).
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
All Wall Controls are supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that
best suits your needs and snap the Covers onto the
Wall Controls (Figure 34).
Install Decorative Wall Plates using the two Screws
provided with each Wall Plate. Leave the Wall Control
in "OFF" mode until Fan installation is completed
(Figure 34).
(Continued)
STANDARD WIRING FOR EXISTING
3-WAY SWITCHES
HOT BLK
GND
3-WAY WIRING DIAGRAM: RETROFIT
HOT BLK
GND
FAN/LIGHT
WALL CONTROL
ALL WALL CONTROLS
SCREWS (2)
DECORATIVE WALL PLATE
Figure 34
22
EXISTING EXISTING
WALL CONTROL
WALL SWITCH
GND
TRAVELER WIRES
BLK
BLK
BLK
GND
SECOND
FAN/LIGHT
TRAVELER
WALL CONTROL
WIRES
(Purchased
Separately)
FAN/LIGHT WALL
SCREWS (2)
CONTROL
....
OFF
ON
WALL BOX
SWITCH COVER
U.L. Model No.: CF915
LOAD
LOAD