Motorola PMPN4156 Guia Del Usuario página 40

Charger Troubleshooting
Problem
Charger powers ON,
but the LED does
not flash Green
for approximately
1 second.
Battery inserted, but
LED remains OFF
and display does not
identify battery.
Fault
Table 13: Troubleshooting
Make sure that the power cord is securely plugged into the
charge and an appropriate AC power outlet, and that there
is power to the outlet.
Inspect fuses and replace as necessary.
This is not applicable to Charger without Status LED.
If battery was inserted into any Pocket (except Pocket #1),
and if Power Saver is Enabled, then press a Menu button.
See Fault.
Check for the correct insertion of the radio or the stand-
alone battery.
Check for contact contamination or corrosion:
• Remove the radio or stand-alone battery from the charger.
• Verify that the battery is an authorized Motorola Solutions
battery listed in Table 14. Other batteries may not charge.
• Inspect the charging contacts on the battery for
contamination or corrosion. Clean the charging contacts
using a dry cloth.
• Inspect the charging contacts in the charger pocket for
contamination or corrosion. If contamination or corrosion
are found, remove power from the charger and clean the
charging contacts using a dry cloth.
Try replacing the battery. If the fault no longer exists, then
take the faulted battery out of service.
If the fault persists with the replacement battery, take the
charger out of service.
40
What to do...