Parker Parflange 1050 Manual De Manejo página 43

Parflange 1050
6.5.1 Operation
Before starting the automatic feeder, make sure that matching feeding plates, feeding
slides, flaring mandrels and clamping jaws are mounted and the correct sleeve size is set
on the rear longitudinal feed.
Work course with automatic feed
• fill the magazine
• switch the feeder to 1
• trigger the start cycle by closing the actuating safety sheet
• the feeder inserts a sleeve onto the tool (the correct position of the sleeve is
checked by a sensor), the clamp is closed, the actuating safety sheet is lowered
• start the assembly operation and clamping by inserting the work piece and pushing
it up to the actuation stop
• take out the finished work piece, attention: the actuating safety sheet is closed
automatically immediately after the work piece has been removed, the next feeding
operation is triggered
42