Parker Parflange 1050 Manual De Manejo página 54

Parflange 1050
Problem
Dies don't close when the
safety flap is locked
Result of forming process
insufficient
Drive is running, but no
motion possible
Sealing surface is too
rough
Tube slips through
No function while machine is
running
Cause
no or wrong power supply
wrong or worn tool,
terminal switch of the
flanging unit is maladjusted
CEE plug is rotating in the
wrong direction, pump is
rotating in the wrong
direction
mandrel is soiled,
mandrel is worn,
lubrication has not been
applied
wrong or worn tool
Wrong direction of rotation /
defect hydraulicpump
53
Solution
• check power supply
•
check main switch
• switch on hydraulic
• check emergency
stop switch position
• check motor
protection switch
• check rotational
direction of the
motor
• check tool /
exchange
• reset terminal switch
(Attention!
Adjustment is valid
for all tools)
reverse the phases of the
CEE plug with a screw-
driver
• clean mandrel
• replace mandrel
• switch on lubrication
clean or replace tool
Check motor rotation / check
delivery flow of the
hydraulicpump