CYBEX gold SOLUTION S2 I-FIX Guia Del Usuario página 7

CERTIFICATION
UN R129/03
SOLUTION S2 I-FIX
Specific Vehicle
CYBEX Solution S2 i-Fix
100 – 150 cm
Recommended from
approx. 3 years to 12 years
Thank you for deciding on the Solution S2 i-Fix when choosing your child seat.
Carefully read the instructions before installing the seat in your car and always
keep these instructions to hand in the designated compartment (1).
IMPORTANT INFORMATION
•
Without the approval of the Type Approval Authority, the child seat may not
be modified or added to in any way.
•
In order to keep your child properly protected, it is absolutely essential that
you use the child seat as described in this manual.
•
This child seat may only be installed on vehicle seats which are approved for
the use of child restraint systems according to the vehicle manual.
•
Only suitable for vehicle seats with automatic three-point belts approved in
accordance with UN regulation 16 or a comparable standard.
•
Do not use any load bearing contact points other than those described in the
instructions and marked on the child restraint.
•
The full surface of the backrest of the child seat must make contact with the
backrest of the vehicle.
•
The shoulder belt must run upwards and back at a recline. It must never run
forward to the upper belt point in your vehicle.
•
The vehicle belt buckle must never cross the belt guide of the seat. If the belt
whip is too long, the child seat is not suitable for use in this position in the
vehicle. In case of doubt please contact the child restraint manufacturer.
•
The three-point vehicle belt must only be passed through the designated
routings. The belt routings are described in detail in this manual and are
marked in green on the child seat.
•
The lap belt must run as low as possible across your child's groin to have
optimum effect in the event of an accident.
•
Before each use make sure that the automatic three-point vehicle belt is
correctly adjusted and fits tightly to the child's body. Never twist the belt!
Booster Seat
100-150 cm
030035
UN Regulation
No. 129/03
Cybex GmbH
Riedingerstr. 18, 95448 Bayreuth
Germany
•
Only an optimally adjusted headrest can offer your child maximum protection
and comfort while ensuring that the shoulder belt can be fitted smoothly.
•
The child seat must always be secured correctly with the vehicle belt in the
vehicle even when not in use.
•
Always ensure that the child seat is never jammed when closing the car door
or adjusting the back seat.
•
The child seat is also tested and homologated without the Linear Side impact
Protectors.
•
If using the car seat on the middle seat of the vehicle's back bench, the
linear side-impact protection (L.S.P.) must never be folded out.
•
Luggage or any other objects present in the vehicle must always be firmly
secured. Otherwise, they may be thrown within the car, which could cause
fatal injuries.
•
The child seat must never be used without the seat cover. Ensure that only
an original CYBEX seat cover is used, as the cover is a key element of the
seat's function.
•
Never leave your child unattended in the car.
•
The parts in the child restraint system heat up in the sun and could
potentially burn your child's skin. Protect your child and the child seat from
direct sun exposure.
•
An accident may cause damage to the child seat that is not identifiable with
the naked eye. Please replace the seat after an accident. In case of doubt,
please consult your dealer or the manufacturer.
•
Do not use this child seat for more than 9 years. The child seat is exposed to
high stress during its product life span, which leads to changes in the quality
of the material with increasing age.
•
The plastic parts can be cleaned with a mild cleaning agent and warm water.
Never use harsh cleaning agents or bleaches!
•
On some vehicle seats made of sensitive materials, the use of child seats
may leave marks and/or cause discolouration. To prevent this, you can
place a blanket or towel or similar underneath the child seat to protect the
vehicle seat.
EN
5