Technical Parameters; Environment Protection - GRAPHITE 59G394 Manual De Instrucciones

CHECKING SANDING BELT
Due to loss in efficiency after long time of using the same sanding belt, replace the belt immediately when
you see it is excessively worn.
REPLACEMENT OF CARBON BRUSHES
Replace immediately used up (shorter than 5 mm), burnt or cracked motor carbon brushes. Always replace
both brushes at a time.
● Unscrew brush covers (2) (fig. H).
● Remove used brushes.
● Remove any carbon dust with compressed air.
● Insert new carbon brushes (brushes should easily move into brush-holders).
● Install brush covers (2).
After the brushes are replaced start the sander with no load and wait until the brushes fit to the
motor commutator. Entrust replacement of carbon brushes only to a qualified person. Only original
parts should be used.
All faults should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Supply voltage
Current frequency
Rated power
Range of sanding belt speed without load
Active sanding surface
Size of sanding belt
Protection class
Weight
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure: Lp = 90,4 dB(A) K = 3 dB(A)
A
Sound power: Lw = 101,4 dB(A) K = 3 dB(A)
A
Weighted value of vibration acceleration: a
Do not dispose of electrically powered products with household wastes, they should be utilized in
proper plants. Obtain information on wastes utilization from your seller or local authorities. Used up
electric and electronic equipment contains substances active in natural environment. Unrecycled
equipment constitutes a potential risk for environment and human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa
Topex) informs, that all copyrights to this instruction (hereinafter Instruction), including, but not limited to, text, photographies, schemes,
drawings and layout of the instruction, belong to Grupa Topex exclusively and are protected by laws accordingly to Copyright and Related
Rights Act of 4 February 2004 (ustawa o prawie autorskim i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments).
Copying, processing, publishing, modifications for commercial purposes of the entire Instruction or its parts without written permission of
Grupa Topex are strictly forbidden and may cause civil and legal liability.

TECHNICAL PARAMETERS

Belt sander
Parameter
= 5,244 m/s
h

ENVIRONMENT PROTECTION

K = 1,5 m/s
2 2
15
Value
230 V AC
50 Hz
800 W
160 - 260 m/min
75 x 146 mm
75 x 457 mm
II
3,1 kg
2019