Jay J3 BACK Manual Del Usuario página 11

ENGLISH
15. Test back release by pressing the release levers (L)
forward and removing the back off the chair. (See
Removal and Replacement section for further details.)
Proper alignment of the mounting hardware and back is
achieved when smooth attachment and release can be
easily done.
16. If proper alignment has not been achieved, adjust the
components until properly aligned.
17. To make micro adjustments, loosen bolts C and F. This
will allow for minor changes in height, depth and angle.
Retighten all bolts to required specs and test back func-
tion and quick-release.
18. Or, to make macro adjustments, loosen, but do not
remove, bolts G, C and F (Figs. 8, 9). Position backrest
to desired height, depth and angle.
19. Retighten all bolts to required specs and test back func-
tion and quick-release.
Adjusting the Four-Point Hardware
To make micro adjustments, loosen bolts C and F. This will
allow for minor changes in height, depth and angle. Retighten
all bolts to required specs and test back function and quick-
release.
Or, to make make macro adjustments, loosen, but do not
remove, bolts G, C and F (Figs. 8, 9). Position backrest
to desired height, depth and angle. Retighten all bolts to
required specs and test back function and quick-release.
J3 Back 106109
B
G
11
I NS TAL LAT ION
K
L
I
J
US=Rev.F, EU=Rev.3.0
Figure 9