ENGLISH
SPINE ALIGN POSITIONING
COMPONENTS
Spine Align Positioning Components are designed to pro-
vide intimately shaped support within an "off-the-shelf" back.
(Depending on your market, Spine Align components may be
included with your back.) To install Spine Align please read
the following directions.
1. Spine Align Positioning Component Installation
a. Have the user remove pressure from the J3 Back by
leaning or sliding partially forward if possible.
b. Release Velcro strip on the top cover flap (Fig. 24)
and lift the cover forward to reveal the inside of the J3
Back.
c. Place the positioning component(s) on the Velcro inside
of the shell (Fig. 25) and reattach the top cover flap.
Pull down making certain that the top seam is aligned
with the top of the shell. If seam does not line up, the
bottom of the cover may need to be loosened (Fig. 26).
d. Have the user test the current Spine Align setup for
comfort and support and repeat steps a-c until adjust-
ment is complete.
e. Multiple configurations and combinations of Spine Align
components can be used. If additional Spine Align
shapes or sizes are required, please contact your deal-
er or Sunrise Medical.
NOTE:
If you require further information on the J3 Spine
Align system, please review our animation at www.
sunrisemedical.com.
Installation of the J3 back is complete.
J3 ACCESSORIES
If you have ordered J3 accessories such as laterals, head-
rests or harnesses please consult the installation instructions
related to those items.
Positioning Components
Large Lumbar
Small Lumbar
Wedge
Curved Shim
Flat Shim
Posterior/Lateral Pelvic
Lateral Shim
Large Bean Bag
Small Bean Bag
J3 Back 106109
Top cover flap
Top cover
flap
Velcro
Top seam
Top cover flap
14
J3 AC CE SSOR IES
Figure 24
Figure 25
Figure 26
Cover
Spine Align
components
US=Rev.F, EU=Rev.3.0