Installation Steps - AVS Bugflector Instrucciones De Instalación

Installation Steps

Clean hood shield mounting locations with an
3
Center hood shield on hood, and align.
5
Apply pressure to all flanges to ensure adhesion of tape to hood surface.
7
Install (4) self tapping screws through the holes on hood shield. A power screwdriver is rec-
ommended but once the screw penetrates the inside metal panel use a regular phillips screw-
8
NOTE: Actual application may vary slightly from drawings.
alcohol pad.
Remove 2" (5 cm) of tape liner from flanges of hood
shield. Ensure that free ends are accessible.
4
With hood shield in its final position, remove remain-
ing tape liner by pulling on free ends.
6
driver the remainder of the way.
Page 2 of 3
free end
Do not overtighten
hood
hood shield
washer