Taking A Measurement - Medline MDS1001U Guía De Operación

Please read the previous section on proper placement of the cuff and proper arm position.
1. After the cuff is properly placed, and you are ready to take a measurement, press the
Start/Stop button. After the display reads "00", the cuff will automatically inflate to an
appropriate pressure. After the inflation, it slowly deflates to take the measurement.
The heart mark "
The cuff will be quite snug for a short while, and this is normal. Try to remain
relaxed, refrain from talking, and be as still as possible during the measurement.
Note: If the device determined that the initial inflation pressure was insufficient,
it will re-inflate to a higher pressure.
3. The device will completely deflate
when the measurement is finished.
The systolic and diastolic pressure
and pulse rate will be displayed.
TO END a measurement for any reason, just press the Start/stop button to turn off
the unit and release the cuff pressure.

TAKING A MEASUREMENT

" indicates that the measurement is in process.
Date/Time
Pulse rate
-15-
Systolic
Diastolic