Setting Date And Time - Medline MDS1001U Guía De Operación

If during a measurement the power drops to an insufficient level, the device will
end the measurement and display the low battery symbol. Please replace the
batteries and repeat the measurement.
If the device can not detect your pulse, it will end the measurement.
Please wait a few minutes, make sure that the cuff is positioned properly, and try again.
The device will automatically shut off 1 minute after a measurement finished.
You can also press Start / Stop button to shut the device off.
For the device with time and date displays, please set them per the following method.
1. Make sure the machine is powered OFF, then hold M (Memory) for 5 seconds, or until
the digits on the screen begin to flash.
2. Press the Start/Stop button to switch between year, date, month, hour and minute.
3. Press the M (Memory) button to advance the digit selected by one value at a time.
NOTE: Holding the M (Memory) button down will advance the value more quickly.

SETTING DATE AND TIME

-16-