Audio Feedback Messages - Stryker SIDNE 0240020925 Guia Del Usuario

Audio Feedback Messages

The SIDNE voice upgrade will alert the user when a voice-specific event occurs.
Voice Message
Voice control
initializing. Please
stand by.
New graphics
detected. Please
wait.
Programming
started. 10%
complete, 20%
complete...
Programming
complete.
Programming
failed.
Voice control
enabled.
Voice control
disabled.
For device specific announcements, refer to the SIDNE Suite and SIDNE Link
user manual (P/N 1000400988).
Note
24
The upgrade cartridge has been inserted into SIDNE® and
SIDNE is initializing voice recognition functionality.
The upgrade cartridge is being updated with new images.
Wait for the next instruction.
The upgrade cartridge is being updated with new images.
Wait for the next instruction.
New images have been programmed to the upgrade
cartridge and voice recognition functionality is ready for
use.
SIDNE® will announce this message only if the
programming failed. If this occurs, follow the steps below:
1. Remove the SIDNE voice upgrade cartridge, restart
SIDNE, and insert the upgrade cartridge again.
2. If the same problem occurs, contact Stryker
Technical Support.
The voice recognition functionality is ready for use.
The upgrade cartridge has been disconnected from
SIDNE® and voice recognition functionality is disabled.
If the SIDNE voice cartridge is not connected to SIDNE,
other methods of device control through SIDNE, including
Switchpoint Infinity and/or the SIDNE wireless tablet, are still
available.
Playback Condition