System Health And System Id Indicator Codes; Códigos Del Indicador Led De Idrac Directo - Dell EMC PowerEdge XR11 Manual Del Usuario

System health and system ID indicator codes

The system health and system ID indicator is located towards the left control panel of the system for Rear Accessed
configuration and towards the right control panel of the system for Front Accessed configuration.
Figure 114. System health and system ID indicator
Table 32. System health and system ID indicator codes
System health and system ID
indicator code
Solid blue
Blinking blue
Solid amber
Blinking amber
Códigos del indicador LED de iDRAC directo
El indicador LED de iDRAC directo se enciende para indicar que el puerto está conectado y se usa como parte del subsistema de
iDRAC.
Se puede configurar la iDRAC Direct mediante un cable de USB a microUSB (tipo AB), que puede conectarse a la laptop o
tableta. La longitud del cable no debe superar los 0,91 metros (3 pies). El rendimiento podría verse afectado por la calidad de los
cables. En la siguiente tabla, se describe la actividad de la iDRAC directa cuando el puerto de la iDRAC directa está activo:
Condition
Indicates that the system is powered on, is healthy, and system ID mode is not active.
Press the system health and system ID button to switch to system ID mode.
Indicates that the system ID mode is active. Press the system health and system ID
button to switch to system health mode.
Indicates that the system is in fail-safe mode. If the problem persists, see the
help section.
Indicates that the system is experiencing a fault. Check the System Event Log
for specific error messages. For information about the event and error messages
generated by the system firmware and agents that monitor system components, go
to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it
up.
Diagnósticos del sistema y códigos indicadores
Getting
117